Meec tools 014035 - Drill Safety Warnings; Technical Data

EN
32
allowed to rotate freely without contacting
the workpiece, resulting in personal injury.
• Always start drilling at low speed and with
the tip of the bit in contact with the
workpiece. At higher speeds the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece,
resulting in personal injury.
• Apply pressure only in a direct line with the
bit, and do not apply excessive pressure.
Bits can bend causing breakage or loss of
control, resulting in personal injury.
Symbols
The following symbols can be of importance
for how you should use your power tool.
Make sure you understand the symbols and
their signicance.
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Torque 50 Nm
Chuck size 2-13 mm
Weight 1310 g
Capacity in steel 13 mm
Capacity in concrete 13 mm
Capacity in wood 30 mm
Speed 0-500/0-1800 rpm
Stroke rate 0-28800 spm
Torque settings 20 + drill modes
Two-speed yes
Voltage 18 V
Percussion function yes
• Do not use damaged or modied
batteries, or power tools that are
damaged. Damaged or modied batteries
can behave unexpectedly and cause a re,
explosion or risk of personal injury.
• Do not expose batteries or power tools to
naked ames or heat. Batteries can
explode when exposed to naked ames or
temperatures higher than 130°C.
• Follow the instructions for charging and
charge the battery only at the
temperature indicated in the instructions.
Incorrect charging or charging outside the
given temperature range can damage the
battery and cause a re.
SERVICE
• Power tools must only be serviced by
qualied personnel using identical spare
parts. This will ensure that the power tool
remains safe to use.
• Never attempt to repair damaged
batteries. The battery must only be
serviced by the manufacturer or at an
authorised service centre.
DRILL SAFETY WARNINGS
Safety instructions for all
operations
• Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
• Hold the power tool by insulated grips
when performing an operation where the
cutting accessory or fasteners may contact
hidden wiring or its own cord. Cutting a
"live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock.
Safety instructions when using
long drill bits
• Never operate at higher speed than the
maximum speed rating of the drill bit.
At higher speeds the bit is likely to bend if