34
2023_001
2 Adjust the handle length to the necessary length.
3 Tighten the length adjustment locking screw.
4.5 To adjust the angle of the front
handle
1 Release the front handle locking screw. (Figure 1,
position 7).
2 Adjust the front handle to the necessary angle.
3 Tighten the handle locking screw.
4.6 To connect to a water supply
1 Push the water hose onto the water inlet until it is
locked in place (Figure 6).
Caution! Make sure that the water hose do not put
the water inlet under any strain.
2 Turn on the water supply.
Note! Make sure that the water nozzles at the front of the
product function correctly.
4.7 To operate the product
1 Hold the product tightly in its front and rear handle.
2 Put the product’s brush in contact with the area to be
cleaned.
3 Push and hold the trigger lockout with your thumb
(Figure 1, position 2).
4 Push and hold the trigger.
5 Release the trigger lockout.
Warning! Do not lock the trigger or the trigger lockout
in their ON position.
6 Move the speed regulator to adjust the rotation speed
of the brush (Figure 1, position 1).
7 Move the product over the part to be cleaned with
steady movements and at a controlled pace.
8 Release the trigger to turn the product o.
Warning! Always allow the product to stop by itself.
Do not stop the product with your hands.
5 Maintenance
Warning! Turn o the product and disconnect the
battery before you do maintenance on the product.
● Always let an authorized service center do the repair of
the product.
● Only use spare parts recommended by the manufacturer.
Install the spare parts according to the manufacturer’s
instructions.
5.1 To clean the product
Caution! Do not use water or liquid detergent on the
product.
● Clean the product after every use.
● Clean the product with a damp cloth and a soft brush.
● Clean the ventilation openings from debris.
6 Storage
● Remove the battery from the product.
● Charge the battery before long time storage.
● Seal the battery terminals before storage.
● Store the product in a dry and frost-free place protected
from direct sunlight.
● Do not store the product in a plastic bag to avoid
moisture and mold.
7 Transportation
Warning! Always transport batteries in accordance
with local and national regulations.
● Turn o the product and let it become cool.
● Remove the battery from the product.
● Seal the battery terminals.
● Safety the product when you transport it.
8 Disposal
8.1 To discard the product
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
To Next Page
Loading...