EasyManua.ls Logo

Meec tools 027161 - Maintenance; To Adjust the Front Handle; To Adjust the Handle Rotation; To Adjust the Telescopic Shaft

Meec tools 027161
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
4.3 To adjust the front handle
Figure 6
1 Loosen the front handle screw.
2 Adjust the front handle to an applicable position.
3 Tighten the front handle screw.
4.4 To adjust the telescopic shaft
Figure 7
1 Loosen the telescopic shaft locking nut.
2 Adjust the telescopic shaft to an applicable length.
3 Tighten the telescopic shaft locking nut.
4.5 To adjust the trimmer angle
Figure 8
1 Push and hold the angle adjustment locking button.
2 Adjust the trimmer unit to an applicable angle.
3 Release the angle adjustment locking button. Make
sure that it clicks back into place.
4.6 To adjust the handle rotation
Figure 9
1 Push the handle rotation latch to release it.
2 Turn the handle until the latch clicks back into place.
4.7 To use the plant protection bar
Fold the plant protection bar up or down. (Figure 10)
4.8 To attach the battery
Warning! Make sure that the power switch is not
pushed when the battery is attached.
Push the battery into the battery holder. Make sure that
the battery clicks into place.
Caution! Do not force the battery into the battery
holder.
4.9 To remove the battery
Push and hold the lock button on the battery and remove
it from the battery holder.
4.10 To operate the product
1 Hold the product tightly with both hands.
2 Push and hold the safety switch.
3 Push and hold the the power switch to start the
product.
4 Tilt the product at an angle of 30°.
5 Sweep the product slowly from right to left to trim the
grass.
Note! Trim long grass in steps from top to bottom.
6 Release the power switch to turn o the product.
5 Maintenance
Warning! Remove the battery before you do any work
on the product.
5.1 To clean the product
Clean the product regularly.
1 Remove the battery from the product.
2 Remove dirt and debris from the product with a soft
brush.
3 Clean the product if needed with a moist cloth and a
mild detergent.
6 Storage
1 Remove the battery from the product.
2 Store the product in a dry and frost-free place
protected from direct sunlight.
Caution! Do not put the product down on its trimmer
guard to avoid deformation of the trimmer guard.
7 Disposal
Make sure that you follow local regulations when you
discard the product. Do not burn the product.

Table of Contents

Related product manuals