Meec tools 731-124 - Maintenance; Storage and maintenance

EN
27
Use
WARNING: Do not start the pump until the pump chamber is lled with water.
1. Rotate the impeller before starting and
check that it can rotate freely.
2. Unscrew the ller plug, ll the pump
chamber with clean water and ret
the ller plug when the chamber is
completely lled and free of residual air.
3. Initially set the valve at a low ow and adjust the ow to the desired level once the water has
started to ow (approved intervals are shown on the type plate).
MAINTENANCE
NOTE:
• Disconnect the pump from the mains supply, before any maintenance is performed on it.
• Do not touch the electric garden pump until it has been switched o and disconnected from the
power supply for at least ve minutes.
Storage and maintenance
• If there is a risk of frost, open the drain plug and drain all water from the pump. Fill the pump
with water before starting it again.
• Drain the water from the pump, if it is not going to be used for a prolonged period.
• Clean the pump housing, impeller and stand, apply anti-corrosion oil and store in a dry place
with good ventilation.
• If the pump has not been used for a long time, it should be lled with water before starting.
• Pay attention to ventilation at high ambient temperatures and/or high humidity. Avoid
condensation on electrical components - risk of electrical fault.
• If the motor becomes very hot or the motor sounds abnormal, immediately shut-o the pump
and check according to the troubleshooting chart.