Troubleshooting
Solid Green LED In normal operation the LED on the bar will ash Green.
This indicates that the bar is operating correctly with good
ionisation performance.
No LED Meaning No power to bar
Action Check 24V Power Supply over pins 1 and 3.
(Brown and Blue wires)
Flashing Green LED Meaning BarMaster remote programmer is connected.
Action After programming, reconnect directly to the
power supply to resume normal operation.
Flashing Red LED Likely cause Contamination causing a drop in performance.
Action Switch off power supply and clean as
described in Maintenance section.
Turn power on and Check for Green ashing
LED
Solid Red LED Likely Cause Abnormal output current detected
Action Check installation for metallic objects on the
emitter pins
Should the solid red LED persist, contact your
Meech distributor.
15
To Next Page
Loading...
