Mefu MF1700-M1+ User Manual

Maintenance
Every day
· Make sure that the machine is not held any hard stuff and the roller is not
damaged.
·check the buttons on the machine
Once a week
·clean the machine
Once a month
·Clean and lubricate the chains and gears.
·Check the power supply and the foot switch to prevent leakage.
· If you have an air compressor with laminator, check and clean with its
manual.
As necessary
·Check the power supply and clean the roller.
10
Troubleshooting
Laminate Your Value
The roller won’t move
up and down
1.Reset the emergency stop button.
2.Reset the controls
(If none of this helps, please contact a
technician)
Control panel dead fault
1. Check power supply or emergency button.
2. If the fuse is burn down, just replace.
The roller can not run
1. Regulate the fraction of the rollers
2. Fix or regulate the chain wheel key on the
motor shaft
3. If Motor or speed controller breakdown,
Just replace the motor or the speed controller.
Snow points
1. Rises up the temperature
2. Clean the surface of graphic
3. If there is some problems with the film,
change the film.
Air bubbles or folds
1. Adjust the pressure of the rollers.
2. Make the printings flat
3. Improve speed or lower temperature.
4. Put the beam weight on printings
Printings go tilt
Regulate the pressure of the rollers.
Folds of films
1. Regulate the film roll's fraction
2. Lower the temperature
Finished products are too
curled
Regulate the
reception roll
tension
of
the
film
or
the

Mefu MF1700-M1+ Specifications

General

Brand	Mefu
Model	MF1700-M1+
Category	Laminator
Language	English