Safety
Laminate Your Value
In order to make a full understanding of the machine, please read this
manual carefully before operation. Take care when operating the
machine, especially if more than one operator is using it.
Power supply
The power supply should meet the requirement of the machine.
Function
The emergency stop function and the mechanical stop function for the
machine should be test in connection with installation, servicing,
maintenance etc.
Operation
In order to make a full understanding of the machine, please read this
manual carefully before operation.
Maintenance
Do not use water to clean the machine in case of short circuit, electric
shock or rust. In order not to hurt the rollers, please do not put any hard
stuff on the machine. Check the chains and gears at a regular time, clean
and lubricate.
Emergency situations
In the event of an emergency, Press the emergency stop button to stop the
laminator in an emergency. Then the machine will run again and the button will
bounce up, when you clockwise rotate to the neutral position.
The rollers are mine parts of the machine, damage
of the rollers will affect the yields. Please rise the
upper roller up after lamination, in case of the
deformation of the lower roller under long time
weight.
4
Red emergency stop buttons are located at the two sides of the machine.
To Next Page
Loading...
General