Mega System Tech ez-11b User Manual


SingleOutletRemotePowerSwitchUserGuide

Setupwiththefreemobileapp:

1. ConnecttheSingleOutletRemotePowerSwitchtotheincludedpower
cordandplugintoapowersource.
2. ConnectoneendoftheincludedEthernetCabletothebackoftheSingle
OutletRemotePowerSwitch,andtheotherendtooneoftheavailable
LANportsonyourrouter.
3. Downloadandinstallthefreeapplication“EZOUTLET”viatheiOSApp
StoreorGooglePlayStore.
4. Pressthe“ADD”buttononthebackofyourswitchoncetoputtheoutlet
in“Add”mode.TheSwitchmustbeinthismodeinordertobepaired
withthemobileapp.TheLEDswillblinkfromGreen>Red>Yellowfor3
minutesuntilthedeviceissuccessfullyadded.Ifyouareunabletogetthe
devicepairedwithin3minutes,youwillneedtostartover.
5. Launchtheapplication.Selectthe“Add”button(foriOS),orthe“+”
button(forAndroid).Anotherscreenwillpopup.Here,youwillhavethe
optiontoaddyourSwitchviaInputID(i.e.themasterpasswordonthe
bottom)ORviaQRCode.
6. TouseInputID,selectthistabandthentypeinthe5digitmaster
password.ToenterusingQRCode,
selectthistabandyourcamerawill
popup,allowingyoutoscanthecode







7. Touchthe“Save”button(foriOS),or
the“Add”button(forAndroid)inthe
applicationandtheoutletwillbe
paired.*Upto4iOSorAndroid
devicescanbepairedtooneswitch.
1. Ifyoueverneedtounpairthe
switchfromyourAndroid/iOS
device,gototheapplication,
selectedit,andtouchthe
MINUSbutton.

Mega System Tech ez-11b Specifications

General

Brand	Mega System Tech
Model	ez-11b
Category	Switch
Language	English

Summary

Setup with the Free Mobile App

Connect to Power and Network

Connect the switch to power and your router via Ethernet cable for initial setup.

Download and Install EZOUTLET App

Get the EZOUTLET application from the iOS App Store or Google Play Store.

Enter Add Mode

Press the 'ADD' button on the switch to enable pairing mode for the mobile app.

Add Switch via App

Launch the app, select 'Add' or '+', then use Input ID or QR code to add the switch.

Pair the Switch

Touch 'Save' (iOS) or 'Add' (Android) in the app to complete the pairing process.

Web Interface Status Overview

Save and Restore Settings

System Restart and Factory Reset Options

Save and Restore Configuration Files

Firmware Upgrade and Factory Reset

Factory Reset Procedure

Hold the 'Add' button for 15 seconds to perform a factory reset, clearing most settings.

Firmware Upgrade Steps

Upgrade firmware via the mobile app; this may reset most settings.

Performing Firmware Upgrade

Automatic Firmware Upgrade

Select your outlet, click 'Upgrade' for automatic upgrade via the app.

Manual Firmware Upgrade

Select 'Manual', enter the switch's LAN IP, and follow prompts for upgrade.