22
DIRECT MODEL
Immersion Heater(s)
To remove the immersion heater:
Replacement:
Wiring (See Figure 16)
Each circuit
must be protected by a suitable fuse and double pole isolating switch with a contact separation of at least 3mm in both poles.
DO NOT OPERATE THE IMMERSION HEATER(S) UNTIL THE MEGAFLO ECO HAS BEEN FILLED WITH WATER.
Operation
DO NOT BYPASS THE THERMAL CUT-OUT IN ANY CIRCUMSTANCES.
Access to Control Unit:
Disconnect from mains supply before removing any covers.
Removing the Control Cover:
Replacing the Control Cover:
DO NOT OVER TIGHTEN
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818