Megger S1-1052/2 User Manual

Figure 2 - The result of a polarity index test (PI)
T est settings: T1 and T2 times set in order to measure the DAR
Test conditions: timer defaults to 10 minutes, as this is required for a PI reading
Figure 3 - The result of a dielectric discharge test (DD)
Test settings: T1 and T2 times set in order to measure the DAR
Test condition: test runs for longer than 10 minutes as this is required
for a PI reading.
9
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I

Megger S1-1052/2 Specifications

General

Brand	Megger
Model	S1-1052/2
Category	Measuring Instruments
Language	English