To Next PageTo Next PageWhy is the distance to fault inaccurate on my Megger TDR2010 Measuring Instruments?
If the distance to fault is inaccurate on your Megger Measuring Instrument, it's likely due to an incorrectly set Velocity Factor. To resolve this, check the VF value for the cable you're testing and adjust the settings accordingly.
What to do if Megger TDR2010 Measuring Instruments keeps turning itself off?
If your Megger Measuring Instrument keeps turning itself off, the battery may not be sufficiently charged. Plug in the charger and charge it for 6 hours. Alternatively, the standby time might be set too low. Access the user settings and increase the standby time.
How to see end of cable on trace with Megger Measuring Instruments?
If you can't see the end of the cable on the trace of your Megger Measuring Instrument, it's probably because the wrong range is selected. From the main screen, press the up navigation button to extend the range.
Why are VF, Impedance, Gain, Pulse inaccessible on Megger Measuring Instruments?
If the VF, Impedance, Gain, or Pulse are inaccessible on your Megger Measuring Instrument, it could be because the instrument is set to Automatic mode. To fix this, press the escape button and change the setting to manual.
What to do if I can’t see a fault I know is there with Megger Measuring Instruments?
If you can't see a fault you know is there on your Megger Measuring Instrument, the gain might be set too low. Switch to manual mode and use the navigation buttons to increase the gain.
Why is the trace very noisy on Megger Measuring Instruments?
If the trace on your Megger Measuring Instrument is very noisy, it's likely that the gain is set too high. Switch to manual mode and use the navigation buttons to decrease the gain.
Why is my Megger TDR2010 not uploading or downloading?
If your Megger Measuring Instrument is not uploading or downloading, the USB cable might be damaged or the wrong type. Make sure to use only a genuine Megger cable and check it for damage before connecting.
Why is the display not visible on Megger TDR2010?
If the display on your Megger Measuring Instrument is not visible, the color settings may be incorrect. Access the user settings and adjust the colors. Alternatively, the instrument might be in power save mode. Press the standby button to return to the display.
How to set Velocity Factor on Megger TDR2010?
If you can't set the Velocity Factor on your Megger Measuring Instrument, it's probably because the cable's Velocity Factor is unknown. To determine it, test a known length of cable.
Why is there no trace even though leads connected to Megger TDR2010?
If there is no trace on your Megger Measuring Instrument even though the leads are connected, the leads might be plugged into the wrong channel. Ensure the test leads are connected to the correct channel.
General| Output Impedance | 50 Ω |
|---|---|
| Display | LCD |
| Power Supply | Rechargeable battery |
| Battery Life | 8 hours |
| Operating Temperature | -10 °C to +50 °C |
| Storage Temperature | -20 °C to +60 °C |
| Weight | 1.5 kg |
| Interface | USB |
| Minimum Range | 1 m |
| Resolution | 0.1 m |
| Velocity Factor | 0.30 to 0.99 |
| Display Type | Graphic |
