To Next Page

To Previous Page

MEI CASHFLOW SC83 Page-16

www.meigroup.com Part # 252055088 G6

UPDATING SOFTWARE

There are two ways of updating the software of a Cashflow SC83

note acceptor.*

1) Via a hand held device called the Cashflow

Portable Programming Module (PPM).

2) By replacing the programmed PROM (Chip Change).*

Portable Programming Module

Connecting the PPM to the CASHFLOW SC83

1. Locate the two USB ports located on the top of the Portable

Programming Module (See fig. 1 below).

2. Plug the type A end of your USB harness to the USB type A

port of the PPM. Plug the type B end of the same USB harness

into the USB type B port of the Cashflow SC83

. (see fig.2).

fig.2

download button

fig.1 (CPM)

Type A USB port Type B USB port

*Note: Once a PROM (chip) is installed, the note acceptor can no longer be programmed via the programming

module (PPM). Installation of a PROM will disable the ability of the programing module (PPM) to communicate with

the note acceptor. Future software changes can only be made by replacing the PROM (chip change).

Questions and Answers:

Need help?

Do you have a question about the MEI Cashflow SC83 Series and is the answer not in the manual?

MEI Cashflow SC83 Series Specifications

General