Why does my Meiko GK 60 Dishwasher say maintenance is required?
Your Meiko Dishwasher indicates that maintenance is required because the set operating hours (P122) or batch number (P123) has been reached. Inform the service department and perform maintenance. After maintenance, reset the maintenance counter (P124).
What to do if my Meiko Dishwasher hood is not closed?
If the hood of your Meiko Dishwasher is not closed, you should check connection S1, check the microswitch adjustment, change the microswitch or replace a defective I/O circuit board.
What to do if my Meiko Dishwasher asks for factory setting parameter list?
To address the 'Factory setting parameter list' message on your Meiko Dishwasher, switch the power supply ON/OFF within 5 minutes and set parameters back to factory settings. This action will be rejected, and parameters will be retained and Information 123 will disappear.
How to resolve the 'Incorrect password / no authorization' error on my Meiko GK 60 Dishwasher?
To resolve the 'Incorrect password / no authorization' error on your Meiko Dishwasher, enter the code once again.
Why is the emergency program active on my Meiko GK 60?
The emergency program on your Meiko Dishwasher may be active, restricting washing, because there is no boiler or tank heating. Check the system to resolve this.
General| Brand | Meiko |
|---|---|
| Model | GK 60 |
| Category | Dishwasher |
| Language | English |
Outlines the operator's responsibilities and obligations to ensure safe machine operation and maintenance.
Details crucial safety measures, including electrical hazards, hot water, and chemical handling.
Emphasizes that electrical work must only be performed by qualified electricians.
Details the critical requirements for safely connecting the machine to the electrical power supply.
Outlines the specifications for connecting the machine to the fresh water supply, including pressure and quality.
Provides guidelines for connecting the machine to the building's waste water disposal system.
Instructions on how to shut down the machine completely in an emergency situation.
Details the safety checks and procedures required before the machine is put into operation.
Details the procedure for entering access codes to unlock different levels of machine functions.
Describes how to access and manage service parameters and machine settings.
Provides step-by-step instructions for viewing and modifying machine parameters.
Detailed guide on viewing and modifying parameters based on user access codes.
Explains how to interpret and clear information displays and basic troubleshooting steps.
Provides detailed explanations of error codes and corresponding troubleshooting actions.
To Next Page
