Need help?Do you have a question about the Meinberg LANTIME M300 and is the answer not in the manual?
General| Operating Temperature | 0°C to 50°C |
|---|---|
| Category | Server |
| Network Protocols | NTP, SNTP, HTTP, HTTPS, SSH, SNMP, IPv4, IPv6 |
| Power Supply | 100-240V AC, 50/60Hz |
| Synchronization Sources | GPS, GLONASS, Galileo, BeiDou |
| Management | Web interface, SNMP |
| Form Factor | 1U 19-inch rackmount |
| Humidity | Max. 85% non-condensing |
| Time Accuracy | ±100 ns (with GNSS), ±1 µs (with PTP) |
Guides through the process of installing and configuring the NTP client.
Configures the parameters for the GPS receiver.
Sets the length of the antenna cable for accurate time delay calculation.
Initiates the GPS receiver to start acquiring satellite signals.
Performs a cold start for the GPS receiver, clearing existing data.
Performs a warm start for the GPS receiver, using stored data.
Sets the initial position for the GPS receiver.
Sets the initial time for the GPS receiver.
Configures the output signals from the GPS receiver.
Enables or disables the various output signals from the GPS receiver.
Configures the parameters for serial data outputs from the GPS receiver.
Sets the time zone for serial output data.
Configures the use of external NTP servers for time synchronization.
Sets the stratum level for the local clock.
Configures the parameters for programmable pulse outputs.
Configures global network settings for the LANTIME system.
Configures the parameters for the network interfaces.
Sets up IPv4 addresses and related network parameters.
Configures IPv6 addresses and autoconfiguration settings.
Configures the system's time zone and daylight saving options.
Configures IPv4 settings and DHCP client behavior.
Configures IPv6 addresses and automatic network configuration.
Manages the password for accessing the timeserver.
Controls access to the web interface via HTTP.
Configures secure shell (SSH) login for remote access.
Generates an SSL certificate for secure HTTPS communication.
Configures authentication methods for NTP communication.
Configures the NTP AUTOKEY feature for secure communication.
Accesses administrative functions like backup and reset.
Manages user accounts and group memberships.
Guides through the process of updating the LANTIME software.
Retrieves diagnostic information for troubleshooting purposes.
Provides detailed statistical data on the timeserver's operation.
Configures global parameters for the PTPv2 protocol.
Configures network settings specific to the PTP interface.
Configures notification settings via the command line interface.
Configures NTP authentication via the command line interface.
Accesses local configuration settings via the command line interface.
Configures the timeserver using SNMP.
Instructions for replacing the lithium battery, intended for skilled personnel.
Guides on backing up configuration to a USB stick.
To Next Page
