meitav-tec TED220-HC11-3S

To Next Page

www.meitavtec.com | support@meitavtec.com File: TED220-HC11-3S_operatingmanual.doc

Page 1 / 2

OPERATING MANUAL TED220-HC11-3S

COMP/STBYON

OFF ON

I II III

COOL HEAT

TEMP

1. Green LED – ‘ON’ LED ON Unit ON

LED OFF Unit OFF

2. Red LED – ‘COMP/STBY’ LED ON Compressor active

LED Flashes 4 Minutes compressor delay

3. On/Off switch ON Turn the unit ON

OFF Turn the unit OFF

4. Temperature adjustment Knob Range: 10°C ÷ 30°C

5. Mode selector COOL Cooling mode

HEAT Heating mode

6. Fan speeds selector I Low speed

II Medium Speed

III High speed

Need help?

Do you have a question about the meitav-tec TED220-HC11-3S and is the answer not in the manual?

Summary

Control Panel Overview

Green LED Indicator

Shows unit power status. ON for active, OFF for inactive.

Red LED Indicator

Displays compressor activity. ON when active, flashes indicating a 4-minute delay.

On;Off Switch Operation

Controls the unit's power, turning it ON or OFF.

Temperature Adjustment Knob

Sets desired temperature from 10°C to 30°C.

Mode Selector Function

Selects between Cooling and Heating modes.

Fan Speed Selector

Adjusts fan speed to Low, Medium, or High.

Installation Guide

Installation Precautions

Disconnect power. Place unit to represent room temp, avoiding drafts/heat/sunlight.

Step-by-Step Installation

Instructions for knob removal, panel separation, mounting, wiring, and reassembly.