Page 2
Remove the batteries at the end of each watering season
or if your AquaTimer
®
will not be used for an extended
period of time.
Do not expose your AquaTimer
®
to temperatures at or
below 32° F (0° C).
To avoid damage to the faucet connection, do not tug on a
hose while it is attached to your AquaTimer
®
.
Inside the coupler at the top of your AquaTimer
®
is a
filter washer. Clean the filter washer regularly to prevent
clogging.
Frequently Asked Questions
Q. Why is the Low Battery light flashing?
A. The Low Battery light will flash to indicate that the charge in
the batteries is low. Change the batteries.
Q. Why will the current program(s) not run?
A. The faucet might be off. Check to make sure the faucet is
turned on.
Q. Can I turn off the watering if it is going to rain?
A. Yes, you can turn off the watering by rotating the Duration
knob to the Off position. Be sure to turn it back to the
desired Duration time when you want to resume the
program.
Q. How do I create a new program?
A. Rotate the Frequency knob to Now and the Duration knob
to Off. Follow the steps described under the section titled
“Programming Your Timer”.
Q. Can I change the watering duration after a program
has been set?
A. Yes, rotate the Duration knob to the desired duration. If the
valve is currently open, it will close and then run the new
duration at the next programmed time.
Delayed Watering
You can delay the first watering cycle of each watering zone
by up to 12 hours by using the small button at the bottom
middle of each zone area. Press the delay button 1 time for
each hour you wish to delay the first start time. The “Low
Battery” light will illuminate when you press the button. The
maximum delay is 12 hours.
For example, if you are programming at 4:00 in the afternoon
and you want your timer to water every 12 hours, but you
want the first watering of the day to start at 6:00 a.m., press
the Delay button two times. Without the delay, the first cycle
would have occurred 12 hours after the timer is programmed
(4:00 a.m.). The delay feature changes that to 6:00 a.m. The
timer will then water every 12 hours after that.
Now Feature
If you would like to water immediately for a set amount of
time, your AquaTimer
®
can help. Turn the Frequency knob to
“Now” and then set the Duration knob to indicate how long
you want the water to run. For example, if you want to water
your lawn or garden immediately and want the water to run for
three minutes, turn the Frequency knob to Now and turn the
Duration knob to 3. The valve will open and then automatically
close after three minutes.
Designed for outdoor use only.
Designed for clean water use only.
Designed for residential use only.
Modelo 3100 - Reloj automático para riego en
dos zonas “Aqua Timer” de Melnor
¡Felicitaciones por la compra de su nuevo reloj automático
para riego en dos zonas “Aqua Timer” de Melnor! El reloj
automático para riego en dos zonas “Aqua Timer” de Melnor
le brindará libertad y flexibilidad para regar su parque y jardín.
Instalación de las baterías
Antes de comenzar a utilizar su reloj automático para riego
en dos zonas “Aqua Timer” de Melnor, usted necesitará
instalar cuatro baterías AA. En la parte posterior e inferior de
su “Aqua Timer” hay una pequeña puerta para las baterías,
que tiene una aleta. Presione la aleta hacia abajo y la puerta
saldrá deslizándose fácilmente. Quite el sostén negro para
las baterías, que se encuentra dentro de la unidad. Inserte
cuatro baterías AA dentro de dicho sostén. Presione el sostén
de las baterías hacia adentro de la unidad y cierre la puerta a
presión, afirmándola en su lugar. Tan pronto como las baterías
se encuentren en el sostén, usted oirá a las válvulas activarse.
Hay una pequeña luz en la parte inferior central de su “Aqua
Timer”, debajo de la cual están escritas las palabras “Low
Battery” (baterías con baja carga). La luz de las baterías
descargadas centelleará cuando la carga de las mismas esté
baja, y la/s válvula/s se cerrarán automáticamente, evitando
un riego excesivo. El reloj automático dejará de funcionar
hasta que se instalen baterías frescas.
Programación de su reloj automático para riego
“Aqua Timer”
Su reloj automático Melnor para riego en dos zonas tiene dos
válvulas, lo que le permite a usted regar automáticamente
dos áreas separadas (o “zonas”) en su parque o jardín, con
dos programas de riego diferentes. Cada zona es controlada
To Next Page
Loading...
