9 | P a g e
Tip-Over Prevention Instructions
Tip-over prevention hardware kit is recommended per assembly instruction below.
Use a stud finder to locate studs when positioning shelving. Secure wall straps to wood
studs whenever possible. Avoid water or electric lines when securing shelf to wall.
Loop STRAPS (L) around rear poles or back of upper shelves.
Mark the installation points through the holes in the strap with a pencil.
For Dry Wall: Drill pilot hole into points and insert ANCHORS (M). Attach with
SCREWS (N).
For Wood Studs: Use SCREWS (N) to attach STRAPS (L) to studs.
Horizontal
Vertical
Need Assistance? Visit us at: samsclub.com/membersmarkhelp
To Next Page
Loading...
