Memmert BE 300 - General Safety Information; Explanation of Signs; Safety Instructions for Load and Environment

Congratulations on your choice of a MEMMERT Oven!
Manufactured in Germany using the latest production techniques and _ finest
materials available, you now posses a technically superior and fully developed
product. Your oven has already been under extensive testing in our factory.
For correct operation of the equipment it is essential to observe the operating and
maintenance instructions below. This will ensure that your equipment will give
many years’ satisfactory service.
Explanation of signs!
These signs refer to a hazard and indicate:
Note the Operating Instructions!
Generai safety instructions.
The physical and chemical properties of your load (e.g.
inflammation temp. etc.) have strictiy to be observed, as
otherwise considerable damages (load, oven, surroundings
of apparatus) can appear.. __
Please note that the Memmert ovens described here are not
explosion-proof (they do not conform to Occupational
Association Regulation VBG 24). They are therefore
unsuitable for drying, evaporating or burning-in of enamels
or similar substances whose solvent may form an
inflammable mixture together with air. There must be no
possibility for inflammable or explosive gas/air mixtures to
form either inside the cabinet or in the immediate
neighbourhood of the equipment.
Severe dust formation in the interior and/or in the
surroundings of the cabinet may lead to deposits of fine
dust inside the equipment which can result in short-circuits.
Adequate precautions should be taken against excessive
dust formation. | |
Transport: ME
Always usegloves! 0 - |
If the units have to be carried, at least 2 persons are required for
this mode of transport depending on size (Model 200 to 500) or
at least 4 persons (Model 600 and 700).
UE/BE 200 - 800/ULE 400-800