Need help?Do you have a question about the Memmert INB500 and is the answer not in the manual?
Defines the product's intended use for sterilisation of medical products via dry heat.
How to set temperature in normal operation mode; oven heats continuously.
Explains the mechanical temperature limiter that switches off heating if a critical temperature is exceeded.
Describes the electronic monitor relay that switches heating to emergency mode if setpoint is exceeded.
Defines the product's intended use for sterilisation of medical products via dry heat.
How to set temperature in normal operation mode; oven heats continuously.
Explains the mechanical temperature limiter that switches off heating if a critical temperature is exceeded.
Describes the electronic monitor relay that switches heating to emergency mode if setpoint is exceeded.
General| Type | Incubator |
|---|---|
| Interior Material | Stainless steel |
| Exterior Material | Powder-coated steel |
| Power Supply | 230 V, 50/60 Hz |
| Over-temperature Protection | Yes |
| Resolution of display for setpoint values | 0.1 °C |
| Temperature Stability | ± 0.1 °C |
| Volume | 500 L |
| Control | Microprocessor control |
| Timer | Programmable up to 99 hours 59 minutes |
| Temperature Uniformity | ±0.5 °C |
To Next Page