Need help?Do you have a question about the Memmert INCO 153 med and is the answer not in the manual?
Details potential hazards like electric shock, suffocation, and burns from CO2 gas.
Steps for accidents, first aid, and emergency shutoff.
Specifies approved uses (cell cultures) and prohibits others (drying, sterilization).
Warns about injury risks during transport and installation.
Performing O2 calibration before initial operation.
Overview of the control panel and setting parameters.
Details permanent operation and setting parameters like temperature, humidity, and CO2.
Illustrates setting temperature and monitoring limits in Normal mode.
Guides setting humidity, CO2, and O2 levels in Normal mode.
Covers setting weekdays, day groups, and on/off times.
Provides a practical example of programming the week time switch.
Lists warnings like DOOR OPEN, TB active, HI-ALARM, LO-ALARM, ASF-ALARM, RH EMPTY.
Provides a table of common errors, causes, and remedies.
Lists more specific errors like CONF message, fan issues, heating icon, and calibration errors.
Explains the Pt100 sensor and double overtemperature fuse.
How the ASF tracks setpoints within a tolerance band and triggers alarms.
Customer-specific calibration using three temperature points.
Step-by-step guide to entering compensation values for temperature calibration.
Customer calibration at 20% and 90% relative humidity.
Customer calibration at 5%, 10%, and 15% CO2 levels.
General| Temperature uniformity | ±0.3°C |
|---|---|
| Temperature stability | ±0.1°C |
| Power supply | 230 V, 50/60 Hz |
| Weight | 85 kg |
| CO2 control range | 0 to 20 % |
| Exterior dimensions (W x D x H) | 710 x 655 x 865 mm |
To Next Page
