33
VCR OPERATION
TAPE SPEED AND MAXIMUM RECORDING TIME
Press the SP/SLP
button to select the recording speed.
Speed selection is automatic during playback. The "SP"
mode is recommended for recording music programs.
1
LOADING
Push the center of the tape until it is automatically
retracted into the VCR.
AUTOMATIC POWER ON
The VCR will turn on automatically.
1
AUTOMATIC PLAY
When loading a cassette tape without the erase prevention tab
intact, playback will start immediately. An inverted video
cassette cannot be inserted.
2
UNLOADING
Tape Cassette
Speed T-60 T-120 T-180
SP
1 hour
2 hours
3 hours
SLP 2 hours 4 hours 6 hours
To unload a video cassette, press the EJECT button on the
unit or press the OPEN/CLOSE/EJECT button on the
remote control; the tape will stop and it will eject out.
1
Pull the cassette out.
The EJECT button can be pressed even when the power
is off and the tape will be ejected.
Always eject the tape when not in use.
2
TO PREVENT ACCIDENTAL ERASURE
After recording, break of
f the erase prevention tab if you
do not wish to record over the tape.
TO RECORD AGAIN
Cover the hole with vinyl tape.
Be careful the tape does not extend past the edges of the
video cassette housing.
1
Erase Prevention Tab
If the unit is in DVD mode, press the DVD/VCR button (on the main unit) or VCR Button (on the remote) to change the unit
to VCR mode, then press the PLAY/PAUSE ®P button to start tape playback.
To Next Page
Loading...
Need help?
General
