OVERVIEW
This document gives details of how to install, test, use and maintain operation of your MF9300 fire
alarm panel.
SYSTEM OPERATION
What To Do At A Glance
The following information tells you what the various indicators, visible on the front panel, mean and
how you should react to them.
INDICATOR STATUS ACTION
GENERAL FIRE ON Fire detected alarms not sounded.
FLASHING Fire detected alarms sounded.
ALARM LINE DELAY ON No action. Alarm line delays are set
up.
FLASHING Fire has been detected. Alarm delay
is in action, check for fire.
SYSTEM FAULT ON Refer to service provider (see front of
this manual for telephone number)
DISABLEMENT FLASHING No action. Zone(s) disabled.
TEST FLASHING Zone in test. If service provider is on
site take no action. Else refer to
service provider (see front of this
manual for telephone number).
REMOTE SIGNAL ISOLATE ON No action. Remote signal output is
isolated.
SUPERVISOR MODE ON No action - you are in Supervisor
mode - see section on `Operating
The Panel`.
FLASHING No action. System is self-checking.
Indicator should go out within 25
seconds.
GENERAL FAULT FLASHING Refer to Appendix B
PAGE 4
To Next Page
Loading...