The fact that a zone is in test will not prevent the panel from recognising and acting upon
fires or faults in other zones.
To take a zone out of the test mode you must go into the Supervisor mode and then press
Reset.
Remote Signal Isolate:
To isolate the Remote Signal output press the Remote Signal Isolate button, whilst in
Supervisor mode. The Remote Signal Isolate indicator will light, the Disablement indicator
will flash and the internal panel buzzer will buzz every 10 seconds. To re-enable the Remote
signal again at a later time simply press the Remote Signal Isolate button again.
The corresponding indicators will extinguish and the panel buzzer will silence itself. Note that
the remote signal isolate facility is not cancelled by a system reset.
Lamp Test Facility:
It is possible to test the indicators and the internal panel buzzer manually. To do this from
within the Supervisor mode the Lamp Test button should be pressed. For the period that the
button is kept depressed all panel indicators should light and the internal buzzer should
sound. Once the button is released the panel will return to the condition it was in prior to the
lamp test.
Exiting from the Supervisor Mode:
This mode will automatically exit if no key press is detected for a period of greater than 15
seconds. Alternatively, if you have finished in the Supervisor mode you may simply press
ENTER. In either case the Supervisor mode indicator will extinguish and the panel will be
back in the Normal mode.
PAGE 7
To Next Page
Loading...