Menvier Security SD1+ - Changing Your Passcode Type; Programmable Output

Changing Your Passcode Type
The SD1+ requires a passcode to be entered to allow access to the
program menus. This passcode is normally 4 digits (
), but
can be changed to 6 digits (
). The default user passcode is
1234. If the passcode is changed from 4 to 6 digits, the last two
digits of the code will default to (00) i.e. 1234 will now become 1234
00.
1.
Ensure that the SD1+ is initialised and the display is showing
“
” (see page 4).
2.
Press 5 and the display will show “ ”.
3.
Press [ and the display will show the code type option that is
currently programmed i.e. “
”.
+
Scroll through the other 3 passcode options “
”, “ ” and “ ”, by pressing the
key.
+
Note: Do not use the following passcode types: 4 digits
followed by enter (
), or 6 digits followed by
enter (
). These are reserved for future use
4.
Press [ to accept the option displayed and return to “ ”.
Programmable Output
The SD1+ has an output that can be programmed to activate
under certain conditions. These conditions are: active when the
SD1+ has been triggered (
), active when the SD1+ has been
acknowledged (
) and, active when the SD1+ has dialled
all numbers and has not been acknowledged (
).
1.
Ensure that the SD1+ is initialised and the display is showing
“
” (see page 4)”.
2.
Press 6 and the display will show “ ”.
3.
Press [ and the display will show the output type that is currently
programmed i.e. “
”.
+
If required, the other 2 output types “ ”, and
"
" can be scrolled through by pressing the key.
4.
Press [ to accept the option displayed and return to “ ”.
5
6 Digit Code
3
C,TYPE-
READY
1
2
4
3
SD1+
????
4, CODE
6, CODE
4+E, CODE
6+E, CODE
5
READY
[
[
B
B
B
4 Digit Code
4 Digit Code + ENT
6 Digit Code + ENT
3
OUTPUT-
READY
1
2
4
3
SD1+
????
ACTIVE
SUCCESS
FAILED
6
READY
[
[
B
B
Has Been Triggered
Has Been Acknowledged
Failed to Communicate