Viewing The Last Call Log
When a call is successfully acknowledged, the SD1+ stores the
event in a “Last Call Log”.
The log may then be viewed as follows:
1.
Ensure that the SD1+ is initialised and the display is showing
“
” (see page 4).
2.
Press 9 and the display will show “ ”.
3.
Press [ and the display will show the Last Call Log i.e. " "if
the log is empty, or ”
” (Alarm on trigger input A
acknowledged by recipient 3). If the display shows “
”
then none of the calls were acknowledged.
4.
Press [ to accept the option displayed and return to “ ”.
Acknowledgement Options
Once the SD1+ has made its call and delivered its message, it
requires a signal to say that the message has been successfully
received. This is done by the recipient pressing the number "8"
button on their telephone. When the SD1+ has been
acknowledged, it will shut down until it is triggered again. This option
determines how many times the unit must be acknowledged
before it shuts down. These options include: Any 1 person (
),
Any 2 people (
), Any 3 people ( ), All 4 people ( )
or nobody at all (
).
1.
Ensure that the SD1+ is initialised and the display is showing
“
” (see page 4).
2.
Press 0 and the display will show “ ”.
3.
Press [ and the display will show the acknowledgement option
that is currently programmed i.e. “
”.
+
If required, the other 4 acknowledgement options
"ANY-2”, “
”, “ ” and “ ”, can be
scrolled through by pressing the
key.
4.
Press [ to accept the option displayed and return to “ ”.
7
3
VIEWLOG-
READY
1
2
4
3
SD1+
????
BLANK
A) --3-
9
READY
[
[
B
No Events Logged
Last Message Sent(A to Tel 3)
3
CLRBY-
READY
1
2
4
3
SD1+
????
ANY - 1
ANY - 2
ANY - 3
ANY - 4
NO-ONE
0
READY
[
[
B
B
B
B
Needs 1 Acknowledgement
Needs 2 Acknowledgements
Needs 3 Acknowledgements
Needs 4 Acknowledgements
Needs No Acknowledgement
To Next Page
Loading...
