Merax A012C - Choosing Your Location; Attaching the Exhaust Hose

4.2 Choose your locaon
 If pped more than 45°, allow the unit to set upright for at least 24
hours before start up.
 Place the unit on a firm, level surface in an area with at least 50cm
of free space around it to allow for proper air circulaon.
 Do not operate in close proximity to walls, curtains, or other objects
that may block air inlet and outlet. Keep the air inlet and outlet free
of obstacles.
 Never install the unit where it could be subject to：
 Heat sources such as radiators, heat registers, stoves or other products that products
that produce heat.
 Direct sunlight
 Mechanical vibraon or shock
 Excessive dust
 Lack of venlaon, such as cabinet or bookcase
 Uneven surface
WARNING!
Install the unit in rooms which exceed 12 m².
Do not install the unit in a place where inflammable gas may leak.
4.3 ATTACH THE EXHAUST HOSE
The air condioner requires being vented outside so that the exhaust air can escape the room which
coming from the appliance contains waste heat and moisture.
Do not replace or extend exhaust hose which will result in decreased efficiency, even worse shu t
down the unit due to low back pressure.
Step 1: Connect the hose connector to one end of the exhaust hose.

31