91
Control systems
COMAND introduction
Main menus of COMAND
Sound
왘 Muting: Press the F shortcut but-
ton in the center console (
컄 page 82).
The sound of the current audio source
is switched on or is muted.
Switching off navigation announce-
ments entirely
왘 Canceling navigation message:
Briefly press F shortcut button dur-
ing an announcement.
왘 Switching off navigation messages:
Press and hold F during an an-
nouncement until the announcement is
switched off.
You will see the message “The driving
instructions have been muted.” for a
short while.
Adjusting volume
1 Thumbwheel
왘 Adjusting: Turn , thumbwheel.
The volume of the currently selected
audio source changes.
i
The components and operating principles of
COMAND can be found on (
컄 page 81).
i
When the sound is muted, you will see the
symbol F in the status line. When you
change the audio source, the sound is automati-
cally switched on. You will be able to hear an-
nouncements from the navigation system even
when the sound is muted.
i
The announcements remain switched off
even if you start a new route guidance or if
COMAND is switched off/on with the o but-
ton.
If you switch COMAND off by removing the
SmartKey from the starter switch and then
switch the ignition back on after more than
3 minutes, the announcements are automatical-
ly switched back on.
To Next Page
Loading...
Need help?
General
