You can stop automatic operation by pushing or
pulling the button again.
Opening and closing roller sunblinds from the
rear
#
Push or pull button 1 to the point of resist‐
ance and hold it until the roller sunblind or
the sliding sunroof has reached the desired
position.
#
Automatic operation: push or pull button 1
beyond the point of resistance and release it.
With the sliding sunroof, a complete opening or
closing process will always pass through "vent
position", a fixed intermediate position. You will
need to operate button 1 twice to execute a
complete opening or closing process.
Rectifying problems with the sliding sunroof
&
WARNING Risk of becoming trapped or
fatal injuries when closing the sliding
sunroof again
If you close the sliding sunroof again immedi‐
ately after it has been blocked or reset, the
sliding sunroof will close with increased or
maximum force.
#
Make sure that no parts of the body are
in the closing area.
#
Release the button immediately if some‐
body becomes trapped.
or
#
Briefly press the button in any direction
during the automatic closing process.
The closing process will be stopped.
The sliding sunroof cannot be closed and you
cannot detect the cause.
If the sliding sunroof is obstructed during closing
and opens again slightly:
#
Immediately after the sliding sunroof has
been obstructed, pull the 3 button down
again to the point of resistance until the slid‐
ing sunroof is closed.
The sliding sunroof will be closed with
increased force.
If the sliding sunroof is obstructed again and
opens again slightly:
#
Immediately after the sliding sunroof has
been obstructed, pull the 3 button down
again to the point of resistance until the slid‐
ing sunroof is closed.
The sliding sunroof will be closed without the
automatic reversing feature.
Anti-theft prevention
Function of the immobiliser
The immobiliser prevents your vehicle from being
started without the correct key.
The immobiliser is automatically activated when
the ignition is switched off, and deactivated when
the ignition is switched on.
When leaving the vehicle, always take the key
with you and lock the vehicle. If the key is left
inside the vehicle, anyone can start the engine.
ATA (Anti-Theft Alarm system)
Function of ATA (Anti-theft Alarm system)
If the ATA system is primed, a visual and audible
alarm is triggered in the following situations:
R
when opening a door
R
when opening the vehicle with the emergency
key element
R
when opening the bonnet
R
when opening the tailgate
After locking the vehicle with the key, the ATA
system is automatically primed.
Opening and closing
67
To Next Page
Loading...
Need help?
General
