32
Practical advice
Installing the two-way radio
3
1 Trim
2 Two-way radio mounting frame trim
3 Ashtray
4 Cigarette lighter
5 Torx screws
6 Lower section of the centre console*
7 Gear lever cover
Remove trim 1 from the centre con-
sole.
Remove trim 2 from the radio mount-
ing frame.
Unscrew the four Torx screws 5 on
both sides of lower section of the cen-
tre console* 6 or the footwell trim.
Remove lower section of the centre
console* 6 or the footwell trim to the
rear. Take care not to damage the two-
way radio loudspeaker in the front-pas-
senger footwell when doing this
( page 15).
Pull out cigarette lighter 4.
Pull out the ashtray insert and remove
ashtray 3. Take care not to damage
the ashtray light when doing this.
You will find information on the ashtray
in the "Controls in detail" section of the
vehicle Owner's Manual.
Pull the back of the bulb holder out of
the ashtray housing.
Lift gear lever cover 7 away from gear
lever trim 9 in an upwards direction.
Installing the two-way radio in the
centre console
To Next Page
Loading...
Need help?
General
