Section 5 - Maintenance
Page 58 90-865253073 DECEMBER 2007
3. Install the oil pump onto the dipstick tube.
mc70571-1
a
c
b
a - Oil pump
b - Dipstick tube
c - Oil drain hose
4. Insert the hose end of the crankcase oil pump onto an appropriate container and usie
the handle to pump until the crankcase is empty.
5. Remove the pump.
6. Install the dipstick.
Changing the Oil Filter
1. Remove and discard oil filter.
a - Oil filter (in‑line exhaust)
b - Oil filter (V‑drive exhaust)
2. Coat the sealing ring on the new filter with engine oil.
3. Install and tighten the oil filter securely following the filter manufacturer's instructions.
Do not overtighten.
4. Remove oil fill cap.
5. Use the dipstick to determine the amount of engine oil required. Replace the dipstick.
6. Add the required amount of the recommended oil to bring the level up to the bottom of
the OK range on the dipstick.
7. With the boat at rest in the water, repeat steps 5 and 6 if necessary.
NOTE: Adding 0.95 L (1 US qt) of engine oil raises the level from the add mark to the top
of the OK range.
All Models
Capacity Fluid Type
Engine oil (with filter)
4.25 L
(4.50 US qt)
Mercury Full‑Synthetic MerCruiser Engine Oil 20W‑40
To Next Page
Loading...
Need help?
General
