OPERATION
33
2. Control shifting by moving the shorter control lever(s). This control
shifts the unit into gear with full lever movement. Move the lever forward
to engage the forward gear. Move lever backward to engage reverse
gear. Place the lever in the center position to shift to neutral. Shifting
should occur only with the engine at idle speed. Always move to the
desired gear position with a quick, firm motion. The control handle
should be adjusted by your dealer to engage forward, reverse, and
neutral when the lever is at the appropriate detent.
a
b
c
4090
a - Throttle control lever
b - Power trim switch
c - Shift control lever
3. See Power Trim section for detailed power trim operating procedures.
Power Trim
Power Trim allows the operator to adjust the drive angle while underway
to provide the ideal boat angle for varying load and water conditions.
IMPORTANT: Each boat manufacturer has the option as to how the power
trim will function on their particular boat. The boat owner/operator must be
aware of how the power trim functions before operating the boat.
To Next Page
Loading...
Need help?
General
