Mercury 1000 - Fitting the Side Panel Rear Retaining Brackets

INSTALLATION
Check the appliance is electrically safe when you have nished.
27
Checking the Parts:
Side panel rear retaining brackets
A052064 - Right-hand
A052067 - Left-hand
Side panels
A051761 - Right-hand
A051759 - Left-hand
Obscuring Trim Side Panel x2
Q050718
Bottom Panel (Plinth)
Colour matched to cooker
Bottom Panel (Plinth)
Front Mounting Brackets
Q050877 - Left-hand
Q050878 - Right-hand
Screws supplied
2x Machine Screw
2x Self-Tapping Screw
Fitting the Side Panel Rear
Retaining Brackets
1. Located at the bottom left and right rear corner of the
cooker, remove the two screws (Fig. 9.5).
2. Fit the left and right retaining brackets to the base
frame and ret and tighten the screws (Fig. 9.5).
Rear left Rear right
Note the position
of locating washer
Base Frame
Base Frame
Fig. 9.5