OUTBOARD INSTALLATION
91
2. Thread the lifting eye into the flywheel hub for a minimum of
five turns.
a - Lifting eye
3. Connect a hoist to the lifting eye.
4. Lift the outboard and place it on the boat transom.
Lifting Eye 91‑90455‑‑1
Threads into the flywheel to
remove the powerhead assembly
from the driveshaft housing, or to
lift entire engine for removal/
installation.
Steering Cable ‑ Starboard Side Routed Cable
1. Lubricate O‑ring seal and entire cable end.
3724
95
Tube Ref No. Description Where Used Part No.
95
2-4-C with Teflon
O-ring seal and entire
cable end
92-802859A
1
To Next Page
Loading...
