OPERATION
37
1. Lower the outboard to the vertical operating position. Make sure all cooling water intake holes are
submerged.
ob00668
2. Open fuel tank vent screw (in filler cap) on manual venting type fuel tanks.
ob00348
3. Squeeze the fuel line primer bulb several times until it feels firm.
ob00349
NOTE: The engine will not start unless the lanyard is set to the "RUN" position.
4. Set the lanyard stop switch to "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
ob00350
5. Shift outboard to neutral (N) position.
F
N
R
3413
To Next Page
Loading...
