250 HP JET DRIVE INSTALLATION MANUAL
Page 45
90-10240040 DECEMBER 2003
Pre-delivery Inspection
Not Check/
Applicable Adjust CHECK BEFORE RUNNING
❏❏Water hose connection/torqued
❏❏Cover plate & adaptor plate
fasteners torqued
❏❏Battery meets engine
specification
❏❏Battery charged & secure
❏❏All electrical connections tight
❏❏All fuel connections tight
❏❏Throttle, shift, & steering adjusted
correctly and fasteners torqued
❏❏Shift cable adjusted to keep
reverse gate above rudder in
forward w/ slack pulled
out of cable and against the stop.
❏❏Pump housing oil level full
(See Owner’s Manual)
❏❏Oil injection reservoir full and bled
❏❏Warning system operational
ON THE WATER CHECK
❏❏Starter neutral safety switch
operational
❏❏Lanyard stop switch operational
❏❏All gauges read properly
❏❏No fuel or oil leaks
❏❏No water leaks
❏❏No exhaust leaks
❏❏Idle:____________RPM
❏❏Forward-Neutral-Reverse
operational
❏❏Steering operational throughout
entire range
❏❏Acceleration test
❏❏WOT:___________RPM
❏❏Boat handling
POST WATER CHECK
❏❏Re-torque adapter plate fasteners
❏❏No fuel, oil, water or exhaust
leaks
❏❏Re-check shift cable adjustment.
Readjust as necessary
To Next Page
Loading...
