OUTBOARD INSTALLATION
126 eng
a. Move the remote control handle from neutral into forward and advance
the handle to the full speed position. Ensure the throttle control lever is
touching the throttle control lever stop screw.
b. Slowly return the handle back to the neutral detent position.
c. Place a mark on the shift cable against the cable end guide.
a - Forward position mark
2. Mark the reverse position as follows:
a. Move the remote control handle into reverse and advance the handle
to the full speed position. Ensure the throttle control lever is touching
the throttle control lever stop screw.
b. Slowly return the handle back to the neutral detent position.
c. Place a mark on the shift cable against the cable end guide.
a - Reverse position mark
3. Mark the center on the shift cable midway between the forward and
reverse marks.
a - Center mark
4361
a
To Next Page
Loading...
