Section 8 - Checklists
Page 94 90-8M0113857 eng DECEMBER 2015
Predelivery Inspection (PDI)
IMPORTANT: This checklist is for packages that are not equipped with Axius. For engine packages equipped with Axius, use
the Axius‑specific checklist, which appears in Section 5 of the Axius Operation Manual.
Perform these tasks before the Customer Delivery Inspection (CDI).
N/A
Check/
Adjust
Item
Service bulletin updates or repairs completed
Drain plug installed and drain valves closed
Seawater inlet valve open
Engine mounts tight
Engine alignment
Drive unit fasteners tightened to specifications
Power trim cylinders fasteners tight
Battery of proper rating, fully charged, secured, with protective covers in place
All electrical connections tight
Exhaust system hose clamps tight
All fuel connections tight
Correct propeller selected, installed, and tightened to specifications
Throttle, shift, and steering system fasteners tightened to specifications
Test OBDM warning system and MIL (light) operation (EC models only)
Steering operation throughout range
Throttle plates open and close completely
Crankcase oil level
Power trim oil level
Sterndrive unit oil level
Power steering fluid level
Closed cooling fluid level
Transmission fluid level
V‑engines: serpentine belt tension
Alternator belt tension (3.0L)
Power steering pump belt tension (3.0L)
SmartCraft gauges calibrated, if equipped
Warning system operation
Trim limit switch operation
To Next Page
Loading...
Need help?
General