MAINTENANCE
82 eng
3. Place lubricant tube into the fill hole and add lubricant until it
appears at the vent hole.
a - Vent plug
b - Lubricant at vent
hole
c - Fill/drain plug
IMPORTANT: Replace sealing washers if damaged.
4. Stop adding lubricant. Install the vent plug and sealing
washer before removing the lubricant tube.
5. Remove lubricant tube and reinstall cleaned fill/drain plug
and sealing washer.
Submerged Outboard
A submerged outboard will require service within a few hours by
an authorized dealer once the outboard is recovered from the
water. This immediate attention by a servicing dealer is
necessary once the engine is exposed to the atmosphere to
minimize internal corrosion damage to the engine.
To Next Page
Loading...
