CYLINDER BLOCK AND CRANKCASE
90-857138R1 MAY 2000 Page 4B–5
Quicksilver Lubricants and Service Aids
Part No. Description
92-809819 Loctite 271
92-809822 Loctite Pipe Sealant w/Teflon-567
92-828000A12 4-Cycle Outboard Oil
Powerhead - General Information
Powerhead “Disassembly” and “Reassembly” instructions are printed in a sequence that
should be followed to assure best results when removing or replacing powerhead compo-
nents. If complete disassembly is not necessary, start reassembly at point that disassembly
was stopped. Usually, complete disassembly of the entire powerhead will be required.
If major powerhead repairs are to be performed remove powerhead from drive shaft hous-
ing. Powerhead removal is not required for 1) valve adjustment and 2) minor repairs on com-
ponents such as ignition systems or carburetor.
To Next Page
Loading...
