IGNITION SYSTEM
Page 2A-8 90-857138R1 MAY 2000
B. RESISTANCE TEST
1. Use an ohmmeter to perform the following primary winding test.
0.02-0.38Ω
2. Use an ohmmeter to perform the following secondary winding test.
NOTE: High tension cables must have spark plug cap removed before testing. Cap contains
5k ohm resistor.
IMPORTANT: To remove spark plug cap from high tension leads, turn cap counter-
clockwise while applying slight outward pressure. DO NOT PULL HARD or lead may
be damaged. To install cap, turn cap clockwise threading cap onto high tension lead.
55852
To Next Page
Loading...
