NOTE: In an emergency, when you must operate the engine and cannot locate
the cause for the high current draw, turn off or disconnect all accessories
connected to the engine and instrumentation wiring. Reset the circuit breaker. If
the breaker remains open, the electrical overload has not been eliminated.
Contact your authorized dealer.
The circuit breaker provides protection for the engine wiring harness and the
instrumentation power lead. To test or reset the circuit breaker:
Reset the breaker by pushing the red button back into the housing.
NOTE: The circuit breaker is located at the starboard rear of the engine in the
electrical center.
A 90‑amp fuse, located on the large post of the starter solenoid, protects the
engine wiring harness if an electrical overload occurs.
OPERATION
34 eng
To Next Page
Loading...
