NOTE: To allow the oil to drain from the filter, loosen the filter enough to break
the internal vacuum. Let the oil drain back into the system for 15 minutes prior
to complete removal of the filter.
9. Remove the oil filter from the adapter and discard the old oil filter and the
old sealing ring.
10. Coat the sealing ring on the new filter with motor oil. Install the new
sealing ring and filter. Tighten the filter securely. Do not overtighten.
11. Using two wrenches, connect the oil drain hose plug to the oil drain hose
and place it back into the boat.
12. Tighten the bilge drain plug.
13. Remove the oil filler cap. Add oil to bring the level up to, but not over, the
"FULL" mark on the dipstick.
IMPORTANT: Always use the dipstick to determine exactly how much oil is
required.
a - Crankcase oil filler cap
Tube Ref
No.
Description Where Used Part No.
25W-50 Synthetic
Blend 4-Stroke
Racing Engine Oil
Crankcase 8M0078013
152
25W-50 Verado
FourStroke
Outboard Oil
Crankcase 92-858084K01
79
MerCruiser 4-Cycle
25W-40 Engine Oil
Crankcase 92-858048K01
DRIVE UNIT OIL (BRAVO ONE XR MODELS)
Mercury Racing Gear Oil is now available for use in your drive unit. This oil will
increase the service life of your drive unit when used in place of other oils. Do
not mix Mercury Racing Gear Oil with any other oil. Drain the drive unit and
monitor bottle, and fill it with the new oil.
The color of Mercury Racing Gear Oil is amber.
MAINTENANCE
60 eng
To Next Page
Loading...
