Mercury 60 - Page 70

Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE Propeller shaft 92-802859A 1
26902
IMPORTANT: To prevent the propeller hub from corroding and seizing to the
propeller shaft (especially in saltwater), always apply a coat of the
recommended lubricant to the entire propeller shaft at the recommended
maintenance intervals, and also each time the propeller is removed.
7. Flo‑Torq I drive hub propellers ‑ Install forward thrust hub, propeller,
propeller nut retainer, and propeller nut onto the shaft.
a - Propeller nut
b - Propeller nut retainer
c - Propeller
d - Forward thrust hub
8. Flo‑Torq II drive hub propellers ‑ Install forward thrust hub, propeller,
replaceable drive sleeve, rear thrust hub, propeller nut retainer, and
propeller nut onto the shaft.
a - Propeller nut
b - Propeller nut retainer
c - Rear thrust hub
d - Replaceable drive sleeve
e - Propeller
f - Forward thrust hub
9. Place the propeller nut retainer over the pins. Place a block of wood
between the gearcase and propeller and tighten the propeller nut to the
specified torque. Align flat sides of the propeller nut with tabs on the
propeller nut retainer.
a
b
c
d
26903
a
b
c
d
e
f
26904
MAINTENANCE
60 eng