EasyManua.ls Logo

Mercury 71712 - Premier ERC Controls and Indicators; Neutral (N) LEDs; Brightness Adjustment; Single-Lever Mode Button

Mercury 71712
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Premier ERCs have an integral, supplemental display, and are available for dual, triple, or quad‑engine configurations. Refer to
ERC Supplemental Display for details.
71950
a
b
c
d
e
g
i
j
j
f
h
Dual-handle, quad-engine premier ERC shown, others similar
Ref Control/LED Function
a
Neutral (N) LEDs (one on
each handle)
Illuminate when the engine is in the neutral gear position. The lights flash when the
engine is in throttle‑only mode.
b
Brightness (+ and )
Increases and decreases the brightness settings for the lights and display (if equipped)
on the ERC and Mercury helm components.
c
1 LEVER
Enables the throttle and shift functions of all engines to be controlled by the port lever.
Refer to SingleLever Mode.
d
TRANSFER
Allows boat control to be transferred to a different helm. (The LED will be ON at the
active helm.) Refer to Helm Transfer.
e
THROTTLE ONLY
Allows the boat operator to increase engine RPM without shifting into gear. Refer to
ThrottleOnly Mode.
f
ACTIVE TRIM (if equipped)
The ACTIVE TRIM button turns the Active Trim feature ON or OFF. Refer to Active
Trim.
Profile and
Changes the selected Active Trim profile.
Active Trim LEDs (1, 2, 3, 4,
5)
Indicates the currently selected Active Trim profile.
NOTE: If the LED indicators are flashing, Active Trim is in setup mode.
g
START/STOP individual
engines
Press to start or stop the indicated engine, as equipped: P (port), PC (port center), C
(center), SC (starboard center), S (starboard)
h
Display and display buttons
(premier ERCs only)
Refer to ERC Supplemental Display for details.
i
START/STOP ALL
ENGINES
Starts or stops all engines. If some, but not all engines are running, pressing this button
will stop all running engines. Refer to Start/Stop All Engines.
j
UP ▲ and DN ▼—trim
control (if equipped)
Raises and lowers the engines/drives for best efficiency, or for conditions such as
shallow water or trailering.
NOTE: Trim switches for the individual engines are located on the front (bow side) of the
ERC.
Some boats are equipped with separately‑mounted trim controls.
Section 1 - DTS Controls and Features
Page 6 90-8M0180922 eng MAY 2021

Related product manuals