Alarms History
Alarm History will show all alarms that have occurred on the vessel. If the fault has occurred multiple times, a number will be
shown in the upper right‑hand corner of the display. The history of a specific alarm can be cleared by selecting the alarm and
pressing ENTER to begin the sequence to clear the fault. A NOTICE will be displayed asking if you want to clear the fault:
press MENU to cancel or ENTER to clear the fault. After clearing the fault, a confirmation will be displayed. Press ENTER to
continue to the next fault.
a - Fault history with incident number
b -
Press MENU to cancel or ENTER to clear the fault
c - Confirmation
About
About is your ready source for the product name, software version, and application version.
a - Product Name
b - Software version
c - Application version
Electronic Remote Control (ERC) Operation
Operation of the shift and throttle is controlled by the movement of the control handle. Push the control handle forward from
neutral to the first detent for forward gear. Continue pushing forward to increase speed. Pull the control handle from the forward
position to the neutral position to decrease speed and eventually stop. Pull the control handle back from neutral to the first
detent for reverse gear. Continue pulling back to increase speed in reverse.
NOTE: On panel mount and single‑handle console ERCs, press the mechanical lock bar when moving the control handle out of
the neutral position.
Section 1 - DTS Controls and Features
90-8M0180922 eng MAY 2021 Page 9
To Next Page
Loading...