OPERATION
45
ob00348
2. Squeeze the fuel line primer bulb several times until it feels firm.
IMPORTANT: To prevent engine flooding, do not squeeze the primer bulb after engine has warmed up.
ob00349
3. Set the lanyard stop switch to "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
ob00350
4. Set the tiller handle gear shift to neutral (N) position.
ob01175
5. If engine is cold, press the fuel primer in twice.
IMPORTANT: Avoid engine flooding ‑ Do not press in the fuel primer if engine is warm. This will inject fuel into
the engine and may cause a hard starting flooded condition.
ob01160
6. Cold Engine ‑ Pull out the choke knob for starting. Push in the choke knob after engine starts to warm up.
To Next Page
Loading...
