Mercury 90 - Page 106

•
Propeller shaft ‑ Refer to Propeller Replacement for removal and
installation of the propeller. Coat the entire propeller shaft with
lubricant to prevent the propeller hub from corroding and seizing to the
shaft.
26902
2. Lubricate the following with 2‑4‑C with PTFE.
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE
Swivel bracket, tilt support lever, tilt
tube, steering cable grease fitting
92-802859A 1
• Swivel bracket ‑ Lubricate through fitting.
• Tilt support lever ‑ Lubricate through fitting.
a - Swivel bracket
b - Tilt support lever
• Tilt tube ‑ Lubricate through fitting.
29478
• Steering cable grease fitting (if equipped) ‑ Rotate steering wheel to
fully retract the steering cable end into the outboard tilt tube. Lubricate
through fitting.
a
b
27873
MAINTENANCE
96 eng