EasyManuals Logo

Mercury 90 Operation Maintenance Warranty Installation Manual

Mercury 90
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
Fuel Filter Removal/Installation Tool 91‑896661
24896
Aids in the removal and installation of the
fuel filter cap assembly.
Installation
1. Lubricate the O‑ring seals with oil.
2. Install the fuel filter and tighten securely.
3. Squeeze the primer bulb until firm and inspect for fuel leakage at the filter.
DRAINING WATER FROM THE FUEL FILTER CHAMBER
NOTE: If a sufficient amount of water has accumulated in the fuel filter
chamber, the warning system will turn on. Draining the water from the fuel filter
chamber is required.
1. Pull the drain hose off the right side fitting. Hold the open end of the hose
over a container.
2. Use a 1/8 in. hex wrench and loosen the drain screw and drain the fuel
filter chamber.
a - Drain hose
b - Right side fitting
c - Drain screw
3. Tighten the drain screw and attach the hose.
c
a
b
23743
MAINTENANCE
84 eng

Table of Contents

Other manuals for Mercury 90

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 90 and is the answer not in the manual?

Mercury 90 Specifications

General IconGeneral
BrandMercury
Model90
CategoryOutboard Motor
LanguageEnglish

Related product manuals