122
D Loosen the alternator as outlined below. Remove and replace the
alternator belt.
E Replace the spacer block between the bracket assembly and the
engine block. Install the two screws using the flat and lock wash-
ers removed previously. Torque the two screws to 21 lb. ft. (28
N·m).
F Install power steering belt. Adjust tension of both drive belts as
outlined in the following.
Power Steering Pump Drive Belt
4 Remove drive belt as follows:
A Loosen power steering pump attaching bolts and mounting bolts.
B Pivot power steering pump toward engine, as required, until belt
can be removed.
C Install new drive belt on pulleys. Adjust tension as outlined in the
following.
Adjusting Tension - Alternator or Power Steering Pump Drive
Belt
5 Loosen alternator or power steering pump attaching bolts and
mounting bolts (if not already accomplished). Adjust tension as
follows:
A Pivot alternator or power steering pump, away from engine, as re-
quired, until the correct deflection of the belt is obtained at location
specified above.
B After obtaining correct tension, torque the alternator and/or power
steering pump attaching bolts and mounting bolts to specifica-
tions. Refer to “Specifications.”
6 Operate the engine for a short period of time. Recheck belt
adjustment.
To Next Page
Loading...
