161
1 Install Quicksilver flushing attachment (or equivalent) over water
intake openings in gear housing.
2 Connect hose between flushing attachment and water source
valve.
3 With drive unit in normal operating position, partially open water
source valve (about 1/2 maximum).
4 Place drive in NEUTRAL, idle speed position and start engine.
CAUTION
Avoid possible engine damage.
• Do NOT run engine continuously at idle rpm.
• Do NOT run engine above 1500 rpm.
5 Slowly advance throttle until engine reaches 1300 rpm
(+/–100 rpm).
CAUTION
Watch temperature gauge on dash to ensure that engine does
not overheat.
6 Operate engine with drive in NEUTRAL, for about 10 minutes or
until discharge water is clear.
7 Slowly return throttle to idle speed position.
8 Stop engine
9 Shut off water and remove flushing attachment.
CA115
Battery Winter Storage
Follow battery manufacturer’s instructions for storage.
To Next Page
Loading...
